How to Configure SIP trunk Between Yeastar Gateway and Anynode (the Software SBC)
How To Configure SIP trunk between AnyNode (SBC) and Yeastar IPPRI Gateway
Configuration between SBC and IP PRI Gateway
How
To Connect Yeastar (Trunk Gateways) with Any node (Session Border Controller)
In this example, we will Connect Yeastar TE100 (IP PRI Gateway) IP address
10.10.26.205
With Any node (SW 4.2.7) 172.29.11.201
Firstly, Create the SIP trunk on the Yeastar Gateway Side:
Gateway
> VoIP Trunk > Add VoIP Trunk
Trunk
Type: Service Provider
Hostname/IP:
172.26.114.220: 5060
Advanced:
Maximum
Channels: you should insert the allowed channels
Transport:
UDP
The other values keep the default settings.
Press Save > Apply Changes
Now we should create the Route List
Press
Gateway > Route List > Add New Route
We
should create a route for the incoming and another for outgoing like below
Now
the status of the trunk from Yeastar side should be Ok
Add
a new node
Create
a SIP Node > PBX or Other Voice Over IP system.
Other
VoIP System
Use
an interface’s address
Use
Port 5060 for UDP/TCP and 5063 for TLS
Node The interconnection via SIP Trunking
Use
URI representation (the IP Address of the Yeastar Gateway)
Leave
it Blank
Next
> Next > Next
Now
the Node state should be ok, and trunk registered.
By Mohamed Soliman
Senior VoIP Engineer
+201001750188
#Yeastar
#Teams
#DirectRouting
#SBC
#Anynode
تعليقات
إرسال تعليق